Fixing the rear valance

Finishing touches to the rear panel

Steve holding most of the new rear valance, made over a block of wood and an anvil

The bottom edge has been folded over a 4mm wire and welded

This area was made in three pieces

The new valance does not fold under quite as sharply as the original
it will be easier to keep free of mud and road dirt

The finished product

looking under the car at the back of the valance

There was also a few pin holes in the rear window frame to fix

Read all about the progress in Chapter three

The 2600 Project index Chapter three

Written by and Copyright ©, Phil. Storr, last updated 4th January 2005